Analysis of three misunderstandings of badge customization

First: the choice of style. Many people see renderings on paper and always want to add a lot of things and elements, but after they do it, they find that there are too many contents. On the contrary, it's not prominent enough to wear. You need to get close to it to have a look. However, if you wear it frequently, it's better not to have too much content. It's enough to highlight the corporate logo. Therefore, how to choose from the customized badges determines whether your final product matches your needs.

Second: the choice of back buckle. At present, the installation process of back buckle is divided into several kinds. Some enterprises make badges with greater collection significance, so the pursuit is more beautiful than practical. Some enterprises require employees to wear them every day, so we need to pay attention to the firmness of back buckle. I can't take it. It's gone a few days. It's troublesome to repair. One is to use high-strength industrial glue to stick it up. This method is manual operation, so the process of sticking is good and bad. But it's not beautiful. Another process is soldering. The pin on the back and the back of the badge are soldered together. Even if you pull it out hard, it won't fall off. However, there is a small disadvantage. Maybe the process of soldering will have a little bit of paint on the back, and the back won't be seen. So you have to choose according to the requirements of your enterprise, the soldering process is usually more expensive, because the needle is relatively small.

Third: the difference between molds. There are two common mold opening processes that Xiaobian often contacts. One is casting, and then pressing, and then trimming. How to describe it? For example, making popsicles at home, first I open a mold, then I pour water in, and then I take out the formed popsicles. This is a kind of technology. The advantage of this method is fast, but the disadvantage is that it is not meticulous enough, especially some relatively small lines, which are difficult to make. In addition, because of this method, some processes can not be added. If we make some demanding works, the finished products made by opening the mold will not work. Another way of opening the mold is to melt the materials first, use a hydraulic press, and first press them into gold, silver and copper cakes. For example, our finished products need a thickness of 2mm. Then we first press them into a 2mm embryo cake, and then combine the carving, mirror, convex yarn and other processes to make a delicate mold. The pattern and process superposition problems can be solved by this method. This method alone will also be time-consuming. This is a combination of traditional badge technology and modern coin making technology. Therefore, some molds can be made of several hundred pieces, while some molds can be made of several thousand pieces, When you find out whether you want the finished product with high quality requirements, and then choose the mold production, don't spend money but don't receive good process effect.

Xiaobian here introduces the classification process of badges to help you distinguish different kinds of badges, so that you can go out of the misunderstanding of badge customization and choose the most suitable badge, which is low cost and cost-effective.

Liu Chunbing, Secretary General of Hubei Artists Association, said that this activity was initiated by Hubei Federation of literary and art circles and Hubei Artists Association. They found enterprises to raise 200000 yuan and planned to make a number of metal commemorative medals. At present, the metal commemorative medallion has been commissioned to be made by relevant units, and it is expected to be transported to Wuhan in about 25 days. If the medical team of Hubei Province has left Han, it will be delivered to the medical staff by mail with the assistance of relevant departments.